![]() This 4TB HDD will actually be inserted in a Thermaltake BlacX docking station, and connected via eSATA to a host PC. Actually, this brings up an interesting point. ![]() Parted Magic can correct alignment if necessary). ![]() Seriously.Īre your computer details correct? You're using XP? If you format with XP, you'll need to check the alignment afterwards on that advanced format drive. Thank you, Seagate.Īnd please, Hitachi, get your Drive Fitness Tool updated to run on your own high capacity advanced format HDDs. Additionally, the tool can run all the available tests on it, even though it is not a Seagate product. I booted from the CD and it correctly identified the Hitachi 4TB HDD and reported its full 4TB capacity. Then I went to Seagate and found their SeaTools for DOS program, and burned it onto CD-R. So I next tried WD's verification tool (can't recall the name), but it wouldn't work because it only operates on WD HDDs. I looked on Hitachi's website and found their disclosure that the Drive Fitness Test tool does not work with HDDs 3TB and up. When I first launched Hitachi's latest version of their Drive Fitness Tool (via a boot CD) to test the 4TB HDD, it detected the 4TB HDD (correct model number) attached to the system, but incorrectly reported that the HDD was 1.8TB in capacity. Even their 2TB HDDs were made with the older 512 byte sector format. ![]() The reason, apparently, is that Hitachi is behind WD and Seagate with respect to manufacturing HDDs with Advanced Sector formatting (4K sectors). It's funny that Hitachi releases the first 4TB 3.5" internal HDD for desktops with no way for its users to verify the drives prior to first use. Seagate's SeaTools for DOS (a boot CD created from a downloadable ISO on Seagate's website). Once it is connected directly, try to go through this procedure again.Īnother option is to try a quick zero-fill from the main menu and then to try a "C - Set Capacity" again.Thanks to those who replied. If the drive is on a controller card then it is possible that the set drive size command may not work. Make sure the drive is connected directly to the motherboard and not to a third-party controller card. If a message in red displays, then an error occurred. Remove the SeaTools diskette/CD, power off the computer for a few seconds, then reboot and check the capacity of the drive again in the BIOS. If you get an OK message in white in the middle of the screen, then the process was successful. Click the "R - Reset to Maximum" button.Click "C - Set Capacity" at the top of the screen.If this is not the current drive, click the "D - Drive" button in the upper left until you see the drive you want to test displayed in the middle of the screen. The model number of the drive currently selected is displayed here. You can see what device is selected by looking in the middle of the screen. ![]() Look at the bottom portion of the window to see what drives are listed and what device number they are. Now choose the drive for which to set the size.Click "I agree" to the license agreement.Once booted from the SeaTools for DOS diskette or CD, the computer should display a screen with a license agreement. 137GB or 32GB) and it is a computer that should support a drive that large, then this would be a time to set the drive size. For example, if the drive is showing up as a smaller capacity in the BIOS (i.e. Sometimes it is necessary to use the SeaTools for DOS software to get the drive back to its native capacity. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |